
Gear · storage
Dry bags and loading a packraft
Where your gear rides changes how the boat handles. Sealed bags and a balanced load keep your sleeping bag dry and the bow pointed where you want it.
Last checked November 2026
Anything you carry on a packraft can end up underwater in a flip, or sit all day in the puddle on the floor. Dry bags keep it dry. Where you put those bags also changes the boat: a well-placed load paddles lightly, a badly placed one makes the raft heavy and stubborn.
How a roll-top works
Nearly all dry bags close with a roll-top. Press out the extra air, fold the top edge over itself at least three times, then clip the buckle. With fewer folds the seal can leak under pressure, and a bag with too much air left inside turns into a stiff balloon that is hard to strap down. A roll-top is splash-proof and survives short dunks well. For long immersion, or for anything that must stay dry, double-bag it.
Closing a roll-top properly
- Shake sand and grit out of the top few inches of the bag.
- Line up the stiffening strip at the mouth so both sides lie flat against each other.
- Squeeze out most of the air while holding the mouth shut.
- Fold the strip over tightly at least three times, keeping each fold flat.
- Bring the buckle ends together and clip, or clip the ends to the side straps if the bag has them.
- Squeeze the bag. If air hisses out, open it and roll again more tightly.
Roll-top vs zip closures
Roll-tops are the default, but you will also see waterproof zippers on duffels, packs and small cases.
| Closure | Seal | Access | Weight and cost | Best use on a packraft |
|---|---|---|---|---|
| Roll-top | Very good when rolled three or more times | Slow, open the whole top | Light, affordable | Sleeping bag, clothes, food, most gear |
| Waterproof zipper (air-tight style) | Excellent if clean and lubricated | Fast, wide opening | Heavier, costly | Camera bags, daily-access duffels, cargo zip tubes |
| Clear phone pouch with press seal | Good for splash, varies when submerged | Use the phone through the window | Very light | Phone and map on the PFD or deck |
| Hard case with O-ring | Excellent and crush-proof | Quick, latch lid | Heaviest per liter | Camera, satellite messenger, batteries |
A waterproof zipper fails mostly from grit and neglect, so it needs cleaning and lube like the cargo zipper on a boat. A roll-top usually leaks because someone closed it in a hurry. If you are diligent about cleaning zippers, a zip bag is quicker to live with; if not, stick with roll-tops.
Sizes that work
| Bag size | Typical use |
|---|---|
| 2 to 5 L | Phone, keys, first aid kit, snacks, inside the boat or clipped to the PFD |
| 10 to 20 L | Sleeping bag, puffy jacket, spare clothes |
| 25 to 40 L | Tent and cook kit on the bow |
| 50 L and up | One big bow bag for the whole load, often a dry liner inside a pack |
Long, narrow bags fit inside tubes. Wide, short bags sit better on the bow. Many packrafters simply line their hiking pack with a heavy dry bag and strap the whole pack to the front of the boat.
Fabric weight
Thin, ultralight bags (silnylon and similar) save ounces inside a pack or tube, where nothing rubs on them. Heavier coated fabrics or vinyl survive being dragged over rock and lashed to the bow all day. A common mix is one tough outer bag or pack liner on the bow, with light bags inside it to sort gear.
Packing order
With a sensible order you never have to empty the whole boat to find a warm hat. Sort gear by when you need it, then pack in reverse.
- Bottom or far end: camp-only items such as sleeping bag, sleeping pad, tent body and camp clothes.
- Middle: cook kit, dinner and breakfast food, stove fuel in its own sealed bottle.
- Top or near end: lunch, rain jacket, warm layer.
- Separate small bag, clipped inside the boat: first aid, repair kit, headlamp, sunscreen, map.
- On the PFD or in a hard case: phone, satellite messenger, knife, whistle.
- Water bottles: clipped low in the boat, not on the bow.
Group by color if your bags come in different colors: one color for sleep gear, one for food, one for clothes. It saves time at camp, especially in the dark.
On the bow or inside the tubes
The classic load sits on the bow, held by straps through the D-rings. It is simple and works on any boat, though it raises the center of gravity and catches wind. The extra bow weight helps in big waves and slows you in tight turns.
Boats with a cargo zipper let you slide long dry bags into the tubes. The weight sits lower, the bow stays clear and nothing snags, at the cost of slower packing and a zipper that needs care. The page on cargo zippers explains how inside-tube storage works and how to keep the zip sealing.
If you pack inside the tubes, put gear in before full inflation and inflate around it, then top off. The inflation guide covers how pressure changes once a loaded boat sits in the sun. The anatomy page shows where D-rings and tie-down points usually sit for a bow load.
Lashing a bow load
- Use two straps minimum, crossing the load so it cannot slide sideways.
- Run straps through the D-rings, not just around the bag.
- Pull the load tight to the bow tube so it does not bounce or lift in waves.
- Tuck or wrap every strap tail.
- Check the load after the first rapid; straps loosen as bags settle.
Balancing the load
A packraft tracks best when weight sits near the middle of the boat, with the paddler slightly aft of center. Too much weight in the stern makes the bow lift and spin in wind. Too much on the bow makes the boat plow and turn sluggishly. Test-paddle a loaded boat in calm water and shift bags until it runs straight with little correction. Keep heavy items, like water and food, low.
A heavily loaded boat is also harder to flip back over and climb into. Practice a re-entry with a full load in calm water before you need it in current; the self-rescue guide walks through the technique.
Protecting electronics and essentials
Phones, cameras, satellite messengers and fire-starting kit deserve a small dedicated bag, or a hard waterproof case, kept within reach. Put the first aid kit and a warm layer where you can get them out without unloading the whole boat. Some paddlers keep a small bag clipped inside the boat with a lunch, a map, and sunscreen.
Double-bag anything that cannot get wet: a phone in a pouch inside a small roll-top, or a down sleeping bag in a light stuff sack inside a heavy dry bag. Put a few silica gel packets in camera bags on humid trips, and let electronics warm up inside the bag before opening it on a cold morning so condensation does not form inside.
Testing for leaks
Test bags at home before the trip, when a leak costs nothing.
- Put a dry paper towel inside the bag and close it as you would on the river.
- Hold the bag under water in a bathtub or sink for a minute, pressing on it.
- Open it and check the towel for damp spots.
- If it leaked, fill the bag with air, close it, and submerge again while squeezing. Bubbles show where the hole or weak seam is.
- Mark the spot, dry the bag, and patch it.
Pinholes usually show up at the corners and along the bottom seam, where bags rub on rock or sand. Small holes in coated fabric bags can be patched with the same tape and adhesive you carry for the boat; the repair guide covers which patch materials suit which fabrics.
Worked example: a two-day desert float
For an overnight on a flat desert river such as the Labyrinth Canyon section of the Green River, a solo packrafter might carry a 50 L pack lined with a heavy dry bag and strapped to the bow, holding the sleeping bag and pad, a light tent, camp clothes and the cook kit in that order. A 10 L bag behind the seat holds lunch, sun layers, a rain shell and the repair kit. A small pouch on the PFD carries the phone and a map. Water is the heaviest item on a desert trip: keep the bottles or a bladder low in the boat near the middle, not stacked on the bow. Check that trip's own page for permits and logistics.
Common mistakes
- Rolling the top only once or twice to save time.
- Packing everything into one big bag, then unloading the bow for a jacket.
- Lashing the load with loose straps and long, flapping tails.
- Putting water and food high on the bow.
- Trusting an old bag without a leak test.
- Storing bags damp and rolled, which grows mildew.
Care
Rinse sand out of the roll-top before folding it; grit wears the seal and can puncture thin fabric. Dry bags fully before storage. Small holes in coated fabric bags can be patched with the same tape you carry for the boat.
For the full list of what goes into those bags, see the packing checklist. If you are hauling a bike instead of a tent, read the bikerafting setup guide. The gear section covers the rest.
What size dry bags do I need for packrafting?
A common set is one large bag or pack liner of 40 to 60 L for the main load, one 10 to 20 L bag for daytime gear, and a small 2 to 5 L bag for essentials.
Are roll-top dry bags fully waterproof?
Rolled three or more times, they handle splashes and short dunks well. For long immersion or critical items, double-bag.
Should I put gear on the bow or inside the tubes?
The bow works on any boat. Inside-tube storage needs a cargo zipper but keeps weight low and the bow clear.
How do I find a leak in a dry bag?
Fill it with air, close it, hold it under water and squeeze. Bubbles show the leak.
Do I need a hard case for my phone?
A good waterproof pouch inside a small dry bag is enough for most trips. A hard case adds crush protection for cameras and messengers.